The "BONUS BRACKET" changes the embroidery field of your machine from an Oval shape to a 145mm x 250mm (6"x10") rectangle. It allows the embroidery to reach in all four corners with ease. The sample shown was embroidered in only one hooping by repeating the 140mm x 250mm design in each corner of  the Super Double-Wide Hoop-It-All frame in one hooping without removing the fabric.

When using the Super Giant Long Hoop-It-All (single wide) the design  would be repeated  two times and fill in the entire inner embroidery area without removing the fabric.

The Bernina Artista "BONUS BRACKET" works with all 4 Artista 730, 200, 630, 640, Aurora 430E, 440E, 450E, HOOP IT ALL Hoops. It enlarges the Sewing Field over 100% for a single position than the Standard Bracket. Your machine must have the "Mega Hoop" internal setting to use the Bonus Bracket.

It will not work on the Artista 185E,165, 180 and 170.

The Standard Bracket has a 17,280 square mm Sewing Field. The "Bonus Bracket" Enlarges the Sewing Field to 37,687 sq. mm, which is a 20,414 sq. mm  LARGER Sewing Field, jn 1 position.

The BONUS Bracket is 137 mm long and looks like the standard Bracket, except it has 2 Blue set Screws instead of the Standard Bracket 3 white set screws. It works on the 355mm (14"), 2 Double-wide Hoops, the 215mm x 584mm, (8.5" x 23") Super Giant Long Hoop and the Big Cap Hoop Kits.

The BONUS BRACKET is Item # H00294,$79.95, which is $17.53 higher than the Standard bracket. Below is a picture of the bonus bracket and if you would like to see some example work using the bracket.

This bracket changes the embroidery field to a rectangle instead of an oval - allowing you to reach all four corners. It can be used on our Big Multi-purpose, Giant-L, and Double-Wide Hoop-It-Alls.click here.

BONUS BRACKET

Made this embroidery possible in a single hooping!

Bonus Bracket

The Bonus Bracket is designed to tell your machine that you are using the center section of the Mega Hoop. It changes the Oval standard hoop limitation allowing the embroidery to reach into all corners. The embroidery above was done on the 23" x 14 1/2" Super Double-Wide Hoop-It-All frame. One corner of the embroidery  was first designed, brought into the machine, and sewn. The frame slides through the Bonus Bracket and then locked into place with special blue  locking screws on the Bracket to complete one section at a time. The bottom section was flipped, the bracket's blue locking screws loosened and the frame slid to the next location to sew off after tightening the locking screws. The frame was then removed with the fabric still attached and turned to repeat again on the other side. And all done in one hooping.

Because of this, less splitting is required. The above took only 4.